MiLAN MIL-L800i Guia do Utilizador

MIL-L800i 8-Port Power over Ethernet Injector Hub USER GUIDE

7 3. Software Utility Installation Berfore you start to remote configuring PD, please intsall the software utility. Through the software utility,

8 5. Click the button to start installation. See Figure 3-2. Figure 3-2

9 6. When installation finishes, click “OK” button to finish. See Figure 3-3. Figure 3-3 7. To run the software utility, go to “Star” Æ “Program

10 4. GUI Management Connecting to PoE Connecting the PoE with PC through the console port. Then, connect the PD (Powered D

11  Device Setting: you can save the device configuration to system, down load the device current configuration to the utility system and enable au

12 System Information  Chip Version: display the system chipset version and revision information.  Firmware Version: display the system firmware

13 Device Setting  Enable Auto-Refresh: It allows the system auto refresh the system parameters. The system auto refresh in every 2 seconds.  Load

14 Port Specific Control  Port Enable: enabling the port. This function is co-responding with “Master Enable” function.  Bypass Detection: bypas

15  LED Status Indicators: current LED indicator display – green, yellow, and red. The LED indicator will change depends on the PD status. ¾ Green

16 Figure 4-5. Port Specific Control interface

Regulatory Approval - FCC Class A - UL 1950 - CSA C22.2 No. 950 - EN60950 - CE - EN55022 Class A - EN55024 Canadian EMI Notice This Class A digital

17 Parametric Information  Discovery R (ohms): display resistance value.  Port Current (mA): display current value.  Port Voltage (V): display

18 5. Technical Specification Standards IEEE802.3af Power over Ethernet IEEE802.3 10Base-T, IEEE 802.3u 100Base-TX Connector Data in: 8 x RJ-4

19 Fault status detect Null: no PD present or PD status is normal Overload: current support over 475mA @ DC 48V and over 50 milliseconds Mode status

20 6. Appendix Console Port Pin Assignments The female DB-9 serial port on the POE hub front panel is used to connect to the switch for out-of-b

21 DB-9 Port Pin Assignments EIA Circuit CCITT Signal Description Switch’s DB9 DTE Pin # PC DB9 DTE Pin # BB 104 RxD (Received Data) 2 2 BA 103 T

90000429 Rev 1P

Table of Contents 1. Introduction...1 Fe

1 1. Introduction Thank you for purchasing MiLAN Technology’s EmPoweredTM Series 8-port Power over Ethernet Injector Hub. Power-over-Ethernet (PoE

2  Auto detect PD and classification of power consumption level  Supports manual control of port power detection and classification  Support au

3 2. Hardware Description This Section describes the hardware of the 8 port Power over Ethernet Hub, and gives a physical and functional overview.

4 LED Indicators The LED Indicators gives real-time information of systematic operation status. The following table provides desc

5 Figure 2-3 Rear panel of the 8 port Power over Ethernet Hub Power On Connect the power cord to the power socket on the rear p

6 Powered Device, ex: SOHO switch or Wireless AP123456789101112AB12x6x8x2x9x3x10x4x11x5x7x1xEthernetA12x6x8x2x9x3x10x4x11x5x7x1xC123456789101112AB12x