MiLAN MIL-RCM16A Especificações descarregar pdf (Página 39)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

FIG. 39-2

36. Bolt the runner cover to RH runner

(FIG. 39-2). Next, reattach chain arm to

RH runner. Then, bolt on the pin collar to

secure chain arm (FIG. 39-2). Repeat

for LH runner.

NOTE: The runner cover, with the “ALIGN

ARROWS” decal, is installed on the

LH runner.

35. Use control box to lower (DOWN)

platform on jack stands (FIG. 39-1) so

inboard edge is 4” below ramp edge.

FIG. 39-1

CHAIN

ARM

RUNNER

COVER

RUNNER

34. Use control box to raise the platform

(UP) slightly and remove 2 jack stands

near the inboard edge (FIG. 39-1).

BOLT

COLLAR

LOCK NUT

37. If necessary, do the BLEEDING

HYDRAULIC FLUID procedure in

this manual.

NOTE: If a new cover is being bolted on

the LH runner, the serial plate

must transferred from old cover

to new cover. Also, a new “ALIGN

ARROWS” decal must be installed

on the new cover.

RAMP

JACK STAND

(AND JACKSTAND

NOT SHOWN)

PLATFORM

4”

INBOARD

EDGE

RAMP

EDGE

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 85 86

Comentários a estes Manuais

Sem comentários

MiLAN MIL-RCM16A Especificações Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com não MiLAN MIL-RCM16A