MiLAN MIL-RCM16A Especificações descarregar pdf (Página 81)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

5. Check for bent and broken parts on the

Liftgate that could interfere with normal

operation.

Make sure Liftgate platform is open and resting on the ground before perform-

ing the following step.

WARNING

To prevent damage when installing valve cartridges & coils, torque valve

cartridge nut to 30 lbs.-in. max.

CAUTION

3. The “E” solenoid valve (FIG. 81-1) may

be stuck in the “open” position. Remove

the “E” solenoid valve (FIG. 81-2). Next,

check the valve cartridge as follows. Push

on the plunger in the valve by inserting small

screwdriver in the open end (FIG. 81-3).

If the plunger does not move with a smooth,

spring-loaded action (approximately 1/8”)

(FIG. 81-3), replace the valve cartridge.

TYPICAL SOLENOID VALVE

REMOVED & DISASSEMBLED

FIG. 81-2

COIL

VALVE

CARTRIDGE

NUT

CHECKING VALVE CARTRIDGE

FIG. 81-3

VALVE

CARTRIDGE

1/8”

4. Reinstall “E” solenoid valve (if good)

(FIG. 81-2) or a replacement. Torque

valve cartridge to 30 lbs.-ft. and hex

nut to 30 lbs.-in.

POWER DOWN PUMP

FIG. 81-1

“E” VALVE

(3-WAY)

1 2 ... 76 77 78 79 80 81 82 83 84 85 86

Sem comentários

MiLAN MIL-RCM16A Especificações Página 81